5
menu
button
Select the Language
During start up, the Envoy LCD panel will
scroll through the available language set-
tings. When you see the setting you prefer,
press the Menu button and hold for two
seconds.
The choices are: English,
Français, Deutsch,
Italiano, and Espanol.
Envoy
Refer to the Enphase Microinverter
installation and operation manual for
information on microinverter installation and
commissioning.
Method B: Power Line Communication Bridges
(Order EPLC-02, EPLC-03 or EPLC-04 separately.)
Use power line communication bridges if the Envoy needs
to be located away from the broadband router.
• Plug one of the bridges into the same AC outlet as
the broadband router and attach an Ethernet cable to
the bridge.
• Plug the other bridge into an AC outlet near the En-
voy and attach the Ethernet cable to the bridge.
• Press and hold the Envoy menu button; release the
button when the LCD displays Get New IP Address.
7
Install the Microinverters and Modules
• Install the PV modules and microinverters
as directed by the installation manuals. For
Enphase installation manuals, go to
http://www.enphase.com/support.
• Use the ArrayGun to scan the microinverters.
For more information, go to
http://enphase.com/products/arraygun.
• As an alternative, you can manually build the
map: Peel the removable serial number label
from each microinverter and afx it to the
respective location on the map.
Envoy
Power line
communication
bridges
broadband
router
192.168.2.140 +Web
0W 0kWh 0
6
Check the Internet Connection
Look for the + Web indication. If it does not appear
within 5 minutes after connecting to the broadband
router, see Troubleshooting
b
.
Method C: Wi-Fi (Enphase Wireless Adapter)
(Order WF-01 separately.)
Requires a wireless router.
• On the Envoy, verify that no Ethernet cable is plugged
into the Envoy RJ45 port.
• Plug the Enphase wireless adapter into the left USB
port (looking at Envoy from the front).
• Verify that the startup message on the LCD screen
reads “R3.8” or later.
- If not, upgrade the Envoy by connecting the En-
voy Ethernet port to the broadband router with
the Ethernet cable that came with the Envoy.
- After the upgrade completes, remove the Ether-
net cable from the Envoy.
• Press and hold the WPS button on the wireless
router for two seconds. On many routers, the WPS
button ashes at this point.
• Return to the Envoy. Press and hold the Envoy menu
button. Release the Envoy menu button when the
LCD displays Enable Wi-Fi WPS.
• Within two minutes an updated IP address appears
on the Envoy LCD screen. This IP address begins
with a “W” to indicate a wireless connection.
• If the connection fails, see Troubleshooting
a
.
Envoy
wireless
router
wireless adapter
Comments to this Manuals